Bob's No.1: A Tribute to Stuart Turner's No.1 and

John Bentley, "The Engineman"

This project was inspired by the Engineman's (John Bentley's) gorgeous naval brass version of the original Stuart Turner steam engine. The proportions of this model cannot be faulted, and I've had a hard time trying to make sure my version is at all true to those aesthetics. This will be a very long term project as I don't intend to even begin any construction until I have both a CNC mill and lathe with which to build the engine. Meanwhile, these pages will serve as a running commentary of how it's going.

September 10: More Details

The 3D model has ben pretty far along for some time but I am just now getting an update posted:

July 13: Rhino 3D Model

I've started by creating a 3D solid model of the engine using Rhino 3D. As of July 13, 2008, this was the current status of that model:

A perspective view...

The right hand side view with a better look at the steam chest...

It took me about 7 hours of work with Rhino to bring the model to this stage.

July 15: Redesign of the Steam Passages and Hot Rod "Porting" Job

The astute observer will note, as several have, that the piston in the above renderings is very stangely shaped. This was to provide clearance for the steam passages. Someone suggested I could vertically mill a groove into the wall of the cylinder to eliminate the bizarre piston shape and I thought it a good idea. I took things a step further since I'll be using a CNC and did a full "porting" job:

In this improved design, a 1/8" diameter end mill cuts a short arc into the cylinder wall to provide clearance for steam entry around the piston. This will also simplify and clean up the steam box, as well as eliminating a difficult setup that would have drilled the ports at an angle to position them closer to the ends of the cylinder.

Click here for a page describing how I accomplished the "porting" in Rhino3D.

Design To Do List

What's needed to finish the 3D model:

- Steam inlet fitting to steam chest and gland

- Steam exhaust fitting on steam chest cover and gland

- Detail on connecting rod to slider fasteners

- Slider gland

- Cylinder mount has an extra bolt hole adjacent to standard.

- Con rod bolts

- Eccentric strap bolts

- Slide valve has an interference with the eccentric rod

- Crankshaft length needs to be adjusted at either end

- Drain taps?

- Oil cups on mains?

Other Valuable Links

Encyclopedia Titanica: Article on Titanic's Steam Engines: Great diagram of how a Stevenson Linkage works on a slide valve engine.

Steam Happens: Some good photos of Stevenson Linkages for steam launch engines.

Maximizing the Efficiency of Steam Locomotives: Interesting data on how to make your steam engine more efficient.